19
A.LEDA WASH
CAUSE AND SOLUTION OF PROBLEMS
THE PROJECTOR WILL NOT SWITCH ON
PROBLEMS
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
REDUCED LUMINOSITY
POSSIBLE CAUSES CHECKS AND REMEDIES
No mains supply.
LED exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
Check the power supply voltage.
Replace the LED. (See instructions).
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).
3
58
(14.09")
2
53
(
9.96")
423
(16.65")
250
(
9.84")
3
60
(14.17")
381
(
15.00")
1
55
(
6.10")
220
(8.66")
320
(12.60")
253
(9.96")
3
74
(14.72")
2
45
(
9.65")
1
55
(
6.10")
584
(22.99")
160
(6.30")
380
(14.96")
395
(15.55")
330
(12.99")
476
(18.74")
360
(14.17")
460
(18.11")
479
(
18.86")
1
60
(6.30")
290
(
11.42")
TECHNICAL INFORMATION
Power supplies available
100-240V 50/60Hz
Input power
•
K20 - 750VA
•
K10 - 450VA
•
K
5 - 170VA
Max 1800VA (with 11 A.leda Wash K5 connected in parallel)
Lamp
LED Osram Ostar RGBW - 15W
Motors
5 (k10 & k20), 2 (k5) stepper motors, operating with microste-
ps, totally microprocessor controlled.
Cooling
• High efficiency die-cast aluminium
• Forced ventilation
Inputs
DMX 512
Working position
Functioning in any position.
Movable body
•
Movement by means of two stepper motors, controlled by
microprocessor.
•
Automatic repositioning of PAN and TILT after accidental
movement not controlled by control unit.
• Travel:
- PAN = 540°
- TILT = 270°
IP20 protection rating
• Protected against the entry of solid bodies larger than 12mm
(0.47”).
• No protection against the entry of liquids.
CE Marking
In conformity with the European Union Low Voltage Directive
2006/95/CE and Electromagnetic compatibility Directive
2004/108/CE.
Weights
• K5: 7.55kg
• K10: 14.10 kg
• K20: 19.30 kg
Komentarze do niniejszej Instrukcji